Plainview Garage Door Help (555) 010-0199

Broken Garage Door Spring Repair in Plainview, TX

If you heard a sudden bang from the garage and now the door barely moves (or the opener strains and stops after a few inches), a broken spring is the most likely cause. Springs do the heavy lifting on a garage door; the opener only guides it. A typical two-car steel door can weigh 150 lbs or more, and without a working spring that whole weight is dead load.

Call (555) 010-0199 Request a call back

Typical cost in Plainview (2026):
JobInstalled
Torsion springs, single-car door~$150–$250
Torsion springs, two-car door~$200–$350
Extension springs~$120–$200
Springs + cables~$200–$500
Published estimate ranges, not quotes. After-hours calls and trip charges to nearby towns cost more. Full cost breakdown

How to tell a spring is broken

What not to do

Typical cost

National cost guides put a pair of torsion springs at roughly $150–$350 installed, and local estimate sites for Plainview publish ranges from about $150 up to $650 depending on door size, spring type, and whether it's an after-hours call. Read our full breakdown: How much does garage door spring replacement cost in Plainview?

Ask whether the quote is for one spring or both. On a two-spring door, the second spring has usually done the same number of cycles and is close to failing too, so replacing both is common practice.

How long springs last

Standard torsion springs are commonly rated around 10,000 cycles (one open plus one close). A household that uses the door four times a day reaches that in about 7 years. Higher-cycle springs (25,000+) cost more up front but last much longer, which is worth asking about if the garage is your main entrance.

Related guides

Areas served

Broken Spring Repair help is available in:

Frequently asked questions

Can I open my garage door with a broken spring?

Not safely with the opener, and lifting it by hand is risky because the full door weight is unsupported and it can drop. If you must get a vehicle out, pull the red emergency release only with the door fully closed, get a second person to help, and lift slowly. The safer option is to call for service.

Should both torsion springs be replaced at the same time?

Usually yes. Springs on the same door wear at the same rate, so when one breaks the other is often near the end of its life. Replacing both saves a second service call.

How long does spring replacement take?

For a technician with the right springs on the truck, a typical residential spring replacement takes about an hour, including balancing and safety-testing the door.

Other garage door services

Opener Repair & ReplacementOpener clicking, humming, or the door reversing before it closes? Common causes in West Texas (dusty safety sensors, remotes, worn gears), quick checks you can do, and when to replace..Off-Track Door & Cable RepairGarage door crooked, jammed, or hanging off its rollers? Why doors come off track, why it's dangerous to force, and what the repair involves..Emergency & Same-Day RepairDoor stuck open at night, car trapped inside, or door fell? Steps to take right now to stay safe and secure, and how to reach a garage door pro who serves Plainview..New Garage Door InstallationThinking about a new garage door? What matters for South Plains wind, hail, heat, and dust: steel gauge, insulation (R-value), wind ratings, and what a quote should include..Maintenance & Noisy Door FixesNoisy, shaky, or slow garage door? A simple maintenance checklist for South Plains dust and heat, the 'balance test', and what a professional tune-up covers..Panel, Dent & Hail Damage RepairHail dents, a bumped panel, or a cracked section? When a single garage door panel can be replaced, when the whole door makes more sense, and tips for insurance claims..
Call (555) 010-0199